FAQs Frequently Asked Questions about Our Products and Solutions

Faça uma Pergunta Faça uma Pergunta

All FAQs (1737 total: showing 1601-1620)

If a device or sensor is not available for selection in the Short Cut program, how can it be added?
Can the data logger be damaged by wiring the sensors to the wrong ports?
How can a floating point value be cast as a long integer?
How can data that has been transmitted from a data logger to LoggerNet then be transmitted to a webhost that displays the data graphically?
Is there a way to only record measurements during the daytime and put the data logger in sleep mode during the nighttime to conserve power?
What is checked during the calibration of a Campbell Scientific data logger?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple data loggers?
Can a data logger be contained in a waterproof enclosure?
What does the PreserveVariables instruction do?
Can more than one SDM device be connected to a data logger?
Can Campbell Scientific data loggers be used with a telemetry system to remotely download data, check parameters, etc.?
Can binary data be received via the serial terminal of a data logger?
What might cause a CRBasic data logger to stop storing data?
How can the amount of time before the memory of a data logger is filled be calculated?
What are the rules regarding when data is deleted from a data logger?
What is a USR drive?
What needs to be done to get a CR3000 program to run on a CR9000 or CR9000X?
If a CR3000, CR1000, CR800, or CR850 has TLS enabled and connects to a server whose certificate is not verified by a “trusted” signer, what will the data logger do?
If a CR3000, CR1000, or CR800-series datalogger has a “machine self-calibration failed” message, what does that mean?
Can CR3000, CR1000, CR800, or CR850 digital terminals be configured to act as RS-232 terminals?

Anterior Próximo