FAQs Frequently Asked Questions about Our Products and Solutions

Faça uma Pergunta Faça uma Pergunta

All FAQs (1748 total: showing 401-420)

Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
What is the current drain of the PWS100?
How is the PWS100 different from a rain gage or snow depth sensor?
Can an HFP01SC provide correct running averages if the scan rate is reduced to 1 minute?
If Short Cut does not list the TCAV on its sensor list, what should be done?
Is it OK to have a TCAV connected to a data logger using a very long cable (100 ft/30 m)?
What are the measuring range, accuracy, and resolution of the TCAV?
What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC?
What type of quality assurance/quality control can be performed on HFP01SC measurements?
For the HFP01SC, is there an available acquisition program that is capable of running in PipeLineMode?
If Short Cut does not list a heat flux plate on its sensor list, what should be done?
Does the HFP01SC have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?
Can the HFP01SC be embedded in railroad ballast, which comprises a blend of coarse rock particles?
If the heat flow from the inside of a wall to the outside of a wall is being measured on the outside, should the blue face or the red face of the HFP01 touch the wall?
If the cable of the HFP01 gets cut, can the cable be soldered to have the sensor work normally?
What is the exact output voltage of the HFP01?
If the speed indicator on a wind monitor stops working, is there a part that can be replaced, or does the whole unit need to be replaced?
Is it possible to get 4 to 20 mA outputs for both wind speed and direction from the 05103?
Do the 05103 and 05103-45 produce the same output?
Can the output of a wind monitor (05103, 05305, 05108, or 05108-45) be changed to analog dc voltage?

Anterior Próximo