RETIRED ›
This product is no longer available. Some accessories, replacement parts, or services may still be available.
MCR1 CSL Memory Card Reader for Mixed-array Dataloggers & DSP4
Services Available
Repair No
Calibration No
Free Support No

Visão Geral

The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.

Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.

Leia mais

imagens

Descrição Técnica

The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.

Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.

Especificações

Memory Configuration Fill-and-stop; data segregated into files by filemarks
Baud Rate Data transfer is typically 9600 or 19,200 baud. Contact Campbell Scientific for information on using the module with Burst Mode.
Supply Voltage 110 Vac to 7.5 Vdc adapter (factory installed) or 6 to 17 Vdc (with modification by user)
Interface Type 25-pin, D-type sub-miniature socket, RS-232C DCE interface
RS-232 Output Levels 5 V (minimum with 3000 Ω load)

Current Drain @ 25°C
Quiescent RTS low = 16 mA (maximum)
Active memory test (worst case) = 30 mA (typical)

RS-232 Input Levels
Low Threshold 0.8 V (maximum)
High Threshold 2.0 V (minimum)
Maximum Input Limit 30 V
Minimum Input Resistance 3500 Ω

Documentos Relacionados

Compatibilidade

Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.

Data Loggers

Product Compatible Note
21X (retired)
CR10 (retired)
CR1000 (retired)
CR10X (retired)
CR200X (retired)
CR206X (retired)
CR211X (retired)
CR216X (retired)
CR23X (retired)
CR295X (retired)
CR3000 (retired)
CR500 (retired)
CR5000 (retired)
CR510 (retired)
CR800 (retired)
CR850 (retired)
CR9000 (retired)
CR9000X (retired)

Communication Devices

Product Compatible Note
DSP4 (retired)

Additional Compatibility Information

Data Logger Considerations

The MCR1 is only compatible with mixed-array data loggers (see below). Data loggers that store data in a table-based format are not compatible. Older data loggers may require a PROM upgrade.

Memory Card

The MCR1 uses one JEIDA 4, PCMCIA card; proper MCR1 operation is guaranteed only with cards tested by Campbell Scientific.