Services Available | |
---|---|
Repair | No |
Calibration | No |
Free Support | No |
The SC-IRDA is an infrared device that allows a PDA handheld to communicate with a data logger without opening the enclosure door. Typically this interface is placed in a compression fitting that has been added to the side of an enclosure. The SC-IRDA infrared sensor is sealed against moisture allowing it to withstand exposure to rain and snow.
Leia maisThe SC-IRDA allows a PDA to communicate with a data logger housed inside an environmental enclosure without opening the enclosure's door. Typically this infrared device is placed in a compression fitting that has been added to the side of an enclosure. The SC-IRDA is sealed against moisture allowing it to withstand exposure to rain or snow.
Power | Supplied by data logger 5 V (on CS I/O port) |
Typical Current Drain |
|
Baud Rate |
|
Communication Range | Up to 20 cm (8 in.) with typical lighting |
Acceptance Angle | 30º |
Communication Standard | Communication conforms to the IRDA low-power SIR standards (specifications as supported by most Palm PCs and laptops) |
PDA Handheld Requirements | Must have an IRDA sensor and an infrared chipset compatible with the SC-IRDA. |
CE Compliance | Complies with EMC standard EN61326:1996. |
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Product | Compatible | Note |
---|---|---|
21X (retired) | ||
CR10 (retired) | ||
CR1000 (retired) | ||
CR10X (retired) | ||
CR200X (retired) | ||
CR206X (retired) | ||
CR211X (retired) | ||
CR216X (retired) | ||
CR23X (retired) | ||
CR295X (retired) | ||
CR3000 (retired) | ||
CR500 (retired) | ||
CR5000 (retired) | ||
CR510 (retired) | ||
CR800 (retired) | ||
CR850 (retired) | ||
CR9000 (retired) | ||
CR9000X (retired) |